[river right]

I just bought a rod case from a friend and he gave me this half a rod with it. I have no Idea what it is and all I have is the butt end and the tip section and it says st Croix on it with a 7/8 weight marking on it. if the handle is anything to measure by (assumeing all 4 sections would be the same length) the full rod would be 14-15 feet ish. also is it possible to have the missing two middle sections made? or would that be to difficult

 

[river right]

upon further inspection I think it might be a 3 piece

 

[ibboone]

Maybe it is a conversion kit with extra tip for a single handed rod.:smokin:



Dan

 

[Nooksack Mac]

You could send it to St. Croix. Ask them to identify it, which they can probably do; and ask them what it would cost to rebuild the missing section(s), which they can probably do, though it may take time.

 

[Deep Swing]

Yes send the Picts and info to st croix, it's not the st croix 1308 13 ft 7/8 wgt spey which I have had for 13 years but they made other models too
Good luck
DS



Sent from my iPhone using Tapatalk

 

[sleestak]

I think St. Croix used to (and maybe still does) sell quite a few blanks. It looks pretty unusual for a factory build and I can't recall ever seeing St. Croix make anything like that for at least the last 20 years so it's almost certainly a custom. My guess would be an older Imperial blank...looks chestnut.

In the event that it is a custom (99%) sure, they might be able to provide you with new sections for the missing pieces, but you'd need to build it out from there.