Spey Pages banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,297 Posts
Discussion Starter #1
after a recent purchase of a pair of rods with spigot ferrules,diff. lengths ,models,, i noticed that they would loosen a bit more than desired after a few casts,this after `warming' them up and setting them a couple extra times,so,i cleaned the inside of the female ends with acetone/Q-tip,then scratched the male end radially,lightly with an automotive scratchpad,same as the green ones used for dishes but built to hold up to solvents,cleaned as above,well,totally cured the problem,only have to set em' once after a couple casts and that's IT,anybody suffering with a loosening problem might try this to see if it works for you,well, there's a nickle's worth:D
 
1 - 1 of 1 Posts
Top