Spey Pages banner

Removing the Accelerator "Hinge"

2K views 2 replies 2 participants last post by  t_richerzhagen 
#1 ·
Dana talked about removing the power hinge. I have an Accelerator 10/11 that I would like to do this with. How does one go about it?
 
Discussion starter · #3 ·
Dana's Reply

I can't remember the exact dimensions but since you have a micrometer you'll
be able to figure it out. Run the line through your thumb and forefinger and
you'll find the hinge--the point where the line "necks down" @ 15ft from the
tip. I would cut the line at the point where it returns to the diameter of
the rest of the line just before and just after the hinge and then splice it
back together and see how it casts for you.

Dana

Thanks to Dana. I will give it a try and report back.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top