Spey Pages banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,829 Posts
Discussion Starter · #1 ·
I know its there somewhere, but can't find it with search. Where does one cut the XLT lines for use with tips 7/8, 8/9, 9/10.
Thanks
 

·
Relapsed Speyaholic
Joined
·
5,562 Posts
Ted,

I'm not sure if it is the same for every line size but I cut my 9/10 at 22' feet. I am pretty sure that is the guidance that was given some time back.
 

·
Registered
Joined
·
886 Posts
This is what you want

XLT: 6/7 7/8 8/9 9/10 10/11
Forward Taper (feet) 87 91 90 92 99
Rear Taper (feet) 19 16 18 14 16
Total Head Length (feet) 108 107 108 106 115
Total Line length (feet) 120 130 130 140 140
Suggested placement of loops (feet from front of line) for sink tip use 18-20 20-22 24-25 27 28
Maximum suggested grain weight (15 foot sinktip) 160 170 200 260 300

well it looks a perfect table here till I post then the wheels come off
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top