I am new to the whole spey world and purchased a few lines trying to dial in my set up, I have the following I won't need
Steelhead Scandi 350 gr lightly used (some lawn casting and a few river casts) SOLD
Airflo tactical Scandi 450 gr used a few times, cut 2 feet from end $20 (box and spool)
Airflo tactical Scandi 550 gr never used ,new in box $35 SOLD
Cortland 444sl running line .031 used few times $15 case and spool PENDING
Shipping a couple of dollars extra depending on location
Let me add the following since it was asked, The Airflo Tacti Scandi 450gr cut, I purchased and after casting it a few times I knew it was too much for my rod so I proceeded to try to sell it, another board, before I found this awesome board, well no one bit, so I decided, what the hell, maybe I can custom make it fit.
After reading and studying the Airflo different lines I figured that by chopping 2 feet off of the front taper from 19 feet to 17 I could keep the ratio of front/belly/rear taper pretty close and basically make it a 400gr. I did not weigh it so I am not 100% sure it is actually 400gr, it shoots fine its just a little too much for my rod still, and if I cut anymore off of the front taper it would throw the ratios completely off.