BEK
07-21-2005, 06:38 PM
Hello,
I am trying to get the curve out of the junction tubing I have. I tried putting it in hot water and then stretching it, but it didn't work. I'm not sure if it was on this board, but I thought I saw something about putting the tubing in a 1/2" pvc pipe capped on both ends and then running it through the dishwasher. Does this sound familiar to anyone and does it work? I'm open to any suggestions as long as they work. Thanks!
Brian
I am trying to get the curve out of the junction tubing I have. I tried putting it in hot water and then stretching it, but it didn't work. I'm not sure if it was on this board, but I thought I saw something about putting the tubing in a 1/2" pvc pipe capped on both ends and then running it through the dishwasher. Does this sound familiar to anyone and does it work? I'm open to any suggestions as long as they work. Thanks!
Brian